Up
|
6 CUTTLER HAMMER 30 AMP CIRCUIT BREAKER DIN MT WMS1D30 o Recognized by UL and CSA under UL 1077 and CSA 22.2. o Third party approved by KEMA according to IEC 898. CE marked in accordance with Low Voltage Directive (LVD) (73/23/EEC). Used to provide overcurrent protection where branch protection (for example UL 489 MCCB) is already provided or not required. Installed as a component within or part of an appliance or a piece of electrical equipment. Ideal replacement for fuses that are applied as a supplementary protector, i.e. in addition to branch protection (if required). 35 mm DIN rail mountable, utilizing metallic extra strength spring clip. Light gray case with gray handle, that is marked O for OFF and I for ON. Features, Benefits, and Functions Current limiting design provides fast short circuit interruption that reduces the let-through energy which can damage the circuit. Thermal magnetic overcurrent protection: o Two levels, categorized by B and D curves o In direct relation to continuous rating of device .. B Curve 3 to 5 X rated current Suited for applications where maximum protection is required for control circuits from low level short circuit faults that could damage the wiring. .. D Curve 10 to 20 X rated current Provides a magnetic range to allow for higher inrush levels during startup that are usually seen with motors, transformers and other high inductive systems Color coded status indicator window red = ON, or green = OFF Cable direct into terminal utilizing ring tung connector 35 mm DIN rail mountable, utilizing extra strength spring clip Applications Cutler-Hammer Supplementary Protectors by Eaton Corporation are ideal for providing protection in a multitude of applications, including: http://www.bb-elec.com/bb-elec/literature/WMS_2405ds.pdf Thanks for looking! If you have any question on this item please call us at 1-800-826-3433 (9 - 5pm Eastern). |