Up
|
* Dimensions: 65 x 61 mm, Temperature: -45 to +85 Celsius * LPC2292 CPU, 16/32-bit, 60 MHZ. Can be replaced with LPC2210/2212/2214/2290/2294 CPU. * External Flash and SRAM: 1M x 16Bit Flash (AT49BV162A), 256K x 16Bit SRAM (IS61LV25616) or 512K x 16Bit SRAM * Powered with a regulated 5V DC using the on-board 1.8V and 3.3V regulators. * Power status indicator LED (D2) * Two debugging modes are available via JTAG_EN Jumper and ETM_EN Jumper * Boot set jumper: can boot from internal flash or external flash by jumper set. * J1, J2, J3, J4 Connector for external bus interface: use 0.1 spacing, 0.025 square inch staight pin headers. J1 and J3 is 20x2 Pins, J2 and J4 is 10x2 Pins. J1 and J2 are used to connect the board to your applied board, J3 and J4 are used to extend upwards Signals routed to J1,J2,J3 and J4 as shown below: LPCEB2000-B Processor Board Signal routing LPCEB2000-B Processor Board Signal routing Philips LPC22xx Microcontroller LPCEB2000-I Development Board for LPCEB2000-B: The LPCEB2000-B can plug into LPCEB2000-I Development Board via J1,J2,J3 and J4 connector headers during development. LPCEB2000-I Development Board expands the two UART to RS-232 drivers, 4x4 keyboard, 2-channel PWM output(one is output to a buzzer, the other is to PWMDAC), 2-channel AD sampling input, I2C bus, 8-digit 8-segment LED display, Analog signal output to a speaker, 20 PIN standard JTAG port and 1 reset button. Plenty of software examples(all in source codes) also provided with the LPCEB2000-I Development Board. With the LPCEB2000-I Development Board, you can develop the LPCEB2000-B quickly. You must have a return authorization number to return your product. Please contact support@GAOTek.com to obtain an authorization number, which shall be valid for 14 days after issued. This product is covered by a warranty of 12 months. You must have a return authorization number to service your product. Please contact support@GAOTek.com to obtain an authorization number. |